User Manual
Page 11 of 20 pages
An accessory top flue blanking plate is available to cover the hole in the stove top plate if the
smoke outlet is connected at the rear of the stove.
Connection to chimney
All the stoves have both rear and top smoke outlet that can be connected to an approved steel
chimney on top or directly out at the rear to a chimney.
Make sure that the chimney is tight and that no false draft is caused around neither the cover
plate, in connection with a covered smoke outlet, nor the cleanout door and pipe connections.
Please note that bent and/or horizontal smoke pipes will reduce the eect of the chimney draft.
Vertical cross-section of smoke flue (Drawing B and C)
B: Top smoke outlet
C: Rear smoke outlet
• Steel chimney ().
• Flue gas elbow (). Fits into smoke flue socket.
• Brick-built jamb of flue ().
• Built-in pipe sleeve (). Fits smoke flue.
• Wall rosette (). Covers disruption to wall around pipe sleeve.
• Joint (). Sealed with packing material.
• Smoke outlets () of the HWAM stove.
• Smoke flue regulating damper ().
• Soot door ().
Fitting the loose parts
Before the stove is installed, you must ensure that all loose parts are fitted correctly. Check that
all insulation plates of the combustion chamber have been properly placed, i.e. that the bottom
plate is horizontal and that the side plates are vertical and reach all the way up to the steel sides
of the combustion chamber and down to the bottom plate.
Vertical cross-section of the stoves (Drawing B):
• The top plate of the stove ().
• Rear smoke outlet (). At the factory this is sealed with a cover plate. The smoke outlet is
therefore hidden behind the plate.
• Top smoke outlet ().
• The smoke shelf (). To be placed on top of the steel rail and on the holders in the sides.
• Two-piece smoke defector plate (). Each half is hung on the hooks located beneath the top plate.
The two halves join in the holders behind the air pipe. Once the stove has been installed, twist
the protection o the two hooks by using pliers or a screwdriver.
• Removable rear plate (). This must always be mounted if the stove is placed next to a com
-
bustible wall.
• Loose heat shield () under the ash pan. This can be used as a lid when the ash pan is removed
for emptying.
Connection of the HWAM
®
SmartControl
TM
Before using the stove it must be connected to power. See the instructions in the separate
manuals for the app IHS SmartControl
TM
or in the Quickguide in order to connect to stove with
the app and the wireless room temperature sensor.