User's manual

44
11. Installing the top plate of the stove: replace the top plate (1) on top of the stove.
12. HWAM 3130: Install the front (11) on the heat-storage compartment again.
An accessory top cover is available to cover the hole in the stove top plate if the smoke outlet is con
-
nected at the rear of the stove.
Changing the smoke outlet from top outlet to rear outlet (drawing H2) - HWAM 3220
1. Removing the rear plate (1). Lift the rear plate and pull it away from the stove so that it disengages
from the guide pins on the bottom plate of the stove. There is a cut-out in the rear plate for the smoke
outlet. Break off the plate (2) within this cut-out to make a hole in the rear plate so there is room for
the smoke outlet.
2. Removing the heat shield (3). There is a heat shield in front of the rear smoke outlet. Break it off and
remove it.
3. Removing the cover plate (4). Remove the cover plate on the back of the stove by removing the three
screws (Torx Bit no. 30).
4. Removing the flue ring (5). Remove the three screws. Lift the flue ring off the top of the stove.
5. Installing the flue ring (5). Insert the flue ring into the smoke outlet hole in the rear of the stove and
secure it with the three screws.
6. Installing the cover plate (4). Place the cover plate above the hole on the top of the stove and secure
it with the three screws.
7. Installing the rear plate (1). Place the rear plate on the guide pins at the back of the bottom plate of
the stove; then press it in towards the stove. Lift the rear plate and press it lightly inwards until it
engages with the guide pins.
Connection to chimney
All the stoves have both rear and top smoke outlet that can be connected to an approved steel chimney on
top or directly out at the rear to a chimney.
Make sure that the chimney is tight and that no false draft is caused around neither the cover plate, in
connection with a covered smoke outlet, nor the cleanout door and pipe connections. Please note that
bent and/or horizontal smoke pipes will reduce the effect of the chimney draft.
Vertical cross-section of smoke flue (Drawing B and C)
B: Top smoke outlet
C: Rear smoke outlet
• Steel chimney (9).
• Flue gas elbow (10). Fits into smoke flue socket.
• Brick-built jamb of flue (11).
• Built-in pipe sleeve (12). Fits smoke flue.
• Wall rosette (13). Covers disruption to wall around pipe sleeve.
• Joint (14). Sealed with packing material.
• Smoke outlets (15) of the HWAM stove.
• Smoke flue regulating damper (16).
• Soot door (17).
Fitting the loose parts
Before the stove is installed, you must ensure that all loose parts are fitted correctly. Check that all insula-
tion plates of the combustion chamber have been properly placed, i.e. that the bottom plate is horizontal
and that the side plates are vertical and reach all the way up to the steel sides of the combustion chamber
and down to the bottom plate.