User's manual

43
HWAM 3110, HWAM 3120, HWAM 3130, HWAM 3220 (Drawing A)
1. Recommended for brick wall
10 cm
1.
For inflammable back wall
10 cm
2.
For inflammable side wall
20 cm
1.
To inflammable wall,corner installation*
13 cm
3.
Distance to furnishings in front
80 cm
*All dimensions in connection with corner installation are only recommendations. Contact your chimney
sweep for a clarification.
For wall-mounting, HWAM 3110 must be placed at least 3 cm above any inflammable flooring. This also
applies to any floorboard placed on the floor.
Remember to pay attention to the applicable regulations concerning the required distance
between the wall and smoke pipe.
The distance to a brick wall is set to faciliate the servicing of the Autopilot system. The stove may be
mounted with wall fittings only on a brick wall. The stove must be taken down when the Autopilot system
is to be serviced.
Requirements for chimney and smoke pipe
The chimney must be of a sufficient height to enable an adequate draft and to prevent smoke problems.
The stove requires a draft of at least 12 Pa.
The chimney must have a minimum opening equivalent to Ø 150 mm. The chimney opening should always
be at least the size of the outlet socket of the stove. The chimney must have an easily accessible soot door.
Smoke pipe and chimney must always be suitable for a stove connection. Ask your HWAM dealer for
more information.
Changing the smoke outlet from top outlet to rear outlet (drawing H1)
- HWAM 3110, HWAM 3120, HWAM 3130
1. Removing the top plate of the stove: lift off the top plate (1).
2. Removing the sides: loosen and remove the screw (2) that holds the two sides together. Loosen
the screw (3) that holds the left side in position lightly, but do not remove it. Lift up the left side (4)
approximately 10 mm and pull it away from the stove to disengage it from the guide pins in the bottom
plate of the stove. Repeat on the right side (5).
3. Hole for the smoke outlet. There is a cut-out on both sides (6) for the smoke outlet. Break off the
plates in these cut-outs to make a hole in both sides that together fit the smoke outlet.
4. Removing the heat shield (7): there is a heat shield (7) in front of the rear smoke outlet. Break it off
and remove it.
5. Removing the cover plate (8): remove the cover plate in the back of the stove by unscrewing the three
screws (Torx Bit no. 30). The cover plate can now be removed.
6. HWAM 3130: Loosen the two screws (10) on each side of the heat storage compartment that support
the front plate of the heat storage compartment (11), and remove the front plate.
7. Removing the smoke ring (9): remove the smoke ring on top of the stove by unscrewing the three
screws. The smoke ring can now be removed.
8. Installing the smoke ring (9): place the smoke ring in front of the smoke outlet hole in the back of the
stove and secure it with the three screws.
9. Installing the cover plate (8): place the cover plate over the smoke outlet hole on top of the stove and
secure it with the three screws.
10. Installing the sides: place the right side (5) on the guide pins in the bottom plate of the stove and press
it in towards the stove. Lift up the side and press it gently inwards until it engages behind the screw
(3) at the top. Tighten the screw (3) again. Repeat with the left side. Finally, screw in the screw (2) that
holds the two sides together.