Assembly instructions

english

asseMbly instructions for coMbustion air systeM

HWAM 2630/HWAM 2640

1. Lift the loose parts (A1) and the top plate (A2) off the stove.

2. Loosen the two bolts (A3) and lift the rear plate (A4) away from the stove.

3. Remove the right and left sides (A5) by loosening the two bolts (A6) at the top of each side.

4. Fresh air connection at the back of the stove – uppermost fresh air hole – (A7): Bolt the

connector bush (C1) to the outside of the cover of the automatic cassette (D1) with the three

bolts supplied and attach the cover plate (E1) so that it closes the hole beneath the combustion

chamber (F1).

Fresh air connection at the back of the stove – lowest fresh air hole – (A8): Fasten the con-

nector bush (C1) the hole in the air box below the combustion chamber (F1) with the accom-

panying three screws and fasten the cover plate (E1) to the external side of the lid (D1) of the

automatic cassette.

Fresh air connection at the bottom of the stove (F2): Bolt the connector bush (C1) to the

hole beneath the combustion chamber (F1) with the three bolts supplied and attach the cover

plate (E1) to the outside of the cover of the automatic cassette (D1).

5. Put the lifting wire (A11) through the hole (D2) in the cover of the automatic cassette. Then bolt

the cover of the automatic cassette (D1) to the automatic cassette (A9). Bolt the cover on the

right and left sides (A10) with the two bolts supplied.

6. Guide the hole in the sealing plate (D3) over the lifting wire (A11). When positioned correctly,

the sealing plate will close the hole (D2) in the cover.

7. Place the ﬂexi-hose (B4) on the connector bush (C1) and fasten with the clamp (B5). Remember

to pull the insulation sleeve (B6) onto the ﬂexi-hose and secure the insulation sleeve with a cable

fastener (B7). For connection through the lowermost fresh air hole of the rear plate (A8), cut the

insulation sleeve at an angle of 30 degrees (B8) for a nicer appearance.

8. Fresh air connection at the back of the stove – uppermost fresh air hole – (A7): There is a

laser-cut cover plate (A7) at the bottom of the rear plate (A4). Cut (G1) this cover (A7) off with

a diagonal cutting nipper (ONLY if the fresh air connection is to go through the uppermost fresh

air hole – A7).

Fresh air connection at the back of the stove – lowest fresh air hole – (A8): There is a laser-

cut cover plate (A8) at the back of the stove. Cut this cover (A8) off with a diagonal cutting nipper

(ONLY if the fresh air connection is to go through the lowest fresh air hole– A8).

Fresh air connection through the bottom of the stove (F2): There is a laser-cut cover plate

(F2) in the bottom of the stove. Break off this cover plate (ONLY if the fresh air connection is to

go through the bottom of the stove).

9. Attach the rear plate to the stove.

10. Reattach the sides of the stove. Replace the loose parts and the top plate on the stove.