Use and Care Manual

REV C 3-10 604220
slot, the deck mowing height is set at its lowest mowing
position. When the lever is located in the “G” slot, the deck
height is at its highest mowing position or transport mode.
To adjust the cutting height, slide the deck cutting height
adjusting lever out of the notch that it is in and raise or lower it
until the desired cutting height is achieved and slide the lever
into that notch. Figure 3-9
Anti-Scalp Wheels
Anti-scalp wheels are standard on Raptor mowers. These anti-
scalp wheels are designed to minimize scalping when mowing
on rough uneven terrain. Figure 3-10
Anti-scalp wheels can be installed in two positions. With the
wheel installed in the bottom hole, the wheel is located 1.60”
(4.06cm) below the mower blades. This setting is preferred
when mowing at cutting heights of 2-1/2” (6.35cm) or higher.
When the wheel is mounted in the top hole, it is located .70”
(1.78cm) below the mower blades. This is the acceptable setting
for mowing at cutting heights of 1-1/2” (3.81cm) or higher
Figure 3-9
Deck cutting height
adjusting lever
Notch
Figure 3-10
Anti-scalp
wheel
Adjusting
holes