Corp. Network Router User Manual

CONFIG MENU (continued)
MIXMATCH PROGRAMMING EXAMPLE
1. Start by making a column for each compressor.
2. The first row must be all 0’s.
3. Each row will be a step. Each step should
increase rack capacity by the smallest increase in
capacity possible.
4. Use an X in the column for a compressor being
on, and a 0 in the column for a compressor being
o ff. It may help to write the capacity in horsepower
to the right of each row.
5. For each row, add the value of each column
with an X in it and put it on the right of each row.
These are the numbers you enter in for each step.
6. Adjust the X’s and the 0’x for equal runtime on
each compressor.
A programming worksheet is available at the back
of this manual.
Any unused steps must have a zero inserted for the
numbers to prevent unwanted compressors from
running.
970307 HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 (Printed in U.S.A.)
P/N 374511B
Page 17
PROTOCOL
™
Hand Held Device
Mixmatch Programming Worksheet
Compr # 1 2 3 4 5 6 Total
HP 4 4 5 6 Total Column
Column Value 1 2 4 8 16 32 HP Value
1 0 0
2 X 4 1
3 X 5 4
4 X 6 8
5 X X 8 3
6 X X 9 6
7 X 10 10
8 X X 11 12
9 X X X 14 11
10 X X X 15 13
11 X X X X 19 14
12 0
13 0
14 0
15 0
16 0