Quick Start Guide

EN
81
Applicable for US market only:
FCC ID: XPY1CGM5NNN
The device complies with part 15 of the FCC
Rules. Operation is subjected to the following
2 conditions:
1. This device may not cause harmful inter-
ference.
2. This device must accept any interference
received, including interference that may
cause undesired operation.
WARNING: To comply with RF exposure
requirements, please maintain a separation
distance of at least 20 cm/ 7 inches from
any part of the product.
Models with a hatch: The supplied label shall
be attached to the product according to fi gure
below.
Models without a hatch: The supplied label
shall be attached to the product according to
fi gure below.
Husqvarna Automower
®
Connect
This device contains the module
FCC ID: XPY1CGM5NNN
5. EC Declaration
of Conformity
Husqvarna AB, SE-561 82 Huskvarna,
Sweden, declares under sole responsibility
that the device Automower® Connect
(2G/3G) with a serial number dating from
week 50, 2017 and onwards (the year is cle-
arly stated on the rating plate, followed by the
serial number), complies with the
requirements of the COUNCIL’S DIRECTIVE:
• Directive on “restriction of use of certain
hazardous substances” 2011/65/EU.
• Directive “relating to radio equipment”
2014/53/EU.
The following standards have been applied:
Electromagnetic compatibility: EN 301489-1
V2.1.1 and EN 301489-52 V1.1.1
Radio spectrum effi ciency: EN 301 511 V9.0.2,
EN 301908-1 V11.1.1 and EN 301908-2
V11.1.1
Automower® Connect is intended for use only
with Automower® 550, Automower® 520,
Automower® 450X, Automower® 440,
Automower® 430X, Automower® 420,
Automower® 310 and Automower® 315,
Automower® 315X.
Huskvarna, 12 December 2017
Lars Roos
Global R&D Director, Electric category
(Authorized representative for Husqvarna AB
Husqvarna Automower
®
Connect
This device contains the module
FCC ID: XPY1CGM5NNN
Connect.indb 81Connect.indb 81 2018-01-16 13:50:322018-01-16 13:50:32