Use and Care Manual
MOC.SLOOTYKSUH 7
aelP se contact 1-888-43-HUSKY for further assistance.
Maintenance
Care and Cleaning
Troubleshooting
Replacing the fuse
Problem Possible Cause Solution
Unscrew the tip of the 12-Volt plug-in (F).
Remove the old fuse and replace with a new 15-Amp fuse.
Reassemble the tip of the 12-Volt plug-in (F).
15A
F
The unit will not start.
The cord is not plugged in.
The fuse in the 12-Volt DC power
cord is blown.
Plug the cord into a working 12-Volt DC
power outlet.
Replace the 15-Amp fuse in the 12-Volt DC power
cord. See Replacing the fuse in the Maintenance
section of this document.
Clean the inator with a non-abrasive slightly damp cloth as needed
Operation – Turn On/Off Light
Remove the 12-Volt inator from the color box.
Connect the 12-Volt power cord (D) into a DC 12-Volt Power outlet.
Press the light switch (C), the light (L) will be turn on with white light, re-press light switch (C), the light (L) will be turn off.
C
L