Use and Care Manual

Operation – Inate Toys and Air Mattresses

J H

Connecting the inator1 Operating the inator2

CAUTION: Do not over‐inate the item being inated.

Follow the manufacturer’s suggested PSI levels on the

item you are inating.

Remove the 12-Volt inator from the color box.

Connect the 12-Volt power cord (D) into a DC 12-Volt Power outlet.

Select the appropriate ination accessory (G, H, or I) and screw it

onto the end of the connect valve adaptor (J). Make sure that the

accessory (G, H, or I) is twist-tight into the connect nozzle (J) so

that the airow to the accessory is not blocked by the tire valve

pin inside the connect nozzle (J).

Twist the ination accessory (G, H, or I) into the desire item you

are inating.

Move the On/Off switch (B) to the I position and inate your item

to the correct pressure.

Move the On/Off switch (B) to the O position when you are

nished inating to turn the inator off.

Remove the ination accessory (G, H, or I) from the connect

valve adaptor (J).

Remove the 12-Volt power cord (D) from the DC 12-Volt power

outlet and allow the inator to cool.

Disconnecting the inator3