Instructions / Assembly
H
AA
Assembly
Attaching the side handle
NOTE: The holes in the cabinet are tapped and do not
require nuts.
□
□
Attach the side handle (B) to the cabinet (C) using four bolts
(BB).
Tighten all bolts with the 10 mm wrench (DD).
□
DD
B
1
2
Do not over tighten the bolts to avoid damage to the finish.
Installing the casters
3
Store the crank handle (K) or crank cap (L) in one of the
drawers when not in use.
NOTE:
Install the crank handle (K) or crank cap (L) into the shaft
□
next to the Husky badge.
K
L
4
Attaching the power strip brackets
□
Attach the power strip brackets (H) to the cabinet (C) using
four bolts (AA).
Tighten all bolts using a screwdriver.
□
Do not over tighten the bolts to avoid damage to the finish.
NOTE: The holes in the cabinet are tapped and do not
require nuts.
□
BB
66
Installing the crank handle or crank cap
Ensure all drawers are securely locked into place using
□ Lay the rolling cabinet (C) on its back. Use the
packaging material to protect the finish.
□ Mount the two swivel casters with brake (D) to the rolling
cabinet (C) using four bolts (CC) per caster. The swivel
casters with brake (D) should be installed on the same
□ Mount the two rigid casters (G) to the rolling
cabinet (C) using four bolts (CC) per caster.
□ Tighten all bolts with a 13 mm wrench (DD).
□
Return the rolling cabinet (C) to its upright position.
CAUTION: Do not over tighten the screws.
□
the key (I) and lock (J) on the rolling cabinet (C).
side as the side handle (B).
CC
G
C
D
C
C