Instructions / Assembly

Assembly
Attaching the side handle Installing the casters
NOTE: The holes in the cabinet are tapped and do not
require nuts.
□
Ensure all cabinet drawers are securely locked into
□ Lay the rolling cabinet (C) on its back on top of the
packaging material to protect the finish.
□ Mount the two swivel casters with brake (D) to the rolling
cabinet (C) usingfour bolts (CC) and washers (BB) per
caster. The swivel casters with brake (D) should be
□ Mount the two swivel casters (G) to the rolling cabinet (C)
using four bolts (CC) and washers (BB) per caster.
□ Tighten all bolts with a 13 mm wrench (DD).
□
Return the rolling cabinet (C) to its upright position.
CAUTION: Do not over tighten the screws.
□
place using the key (I) and lock (J) on the rolling cabinet (C).
installed on the same side as the side handle (B).
□
Attach the side handle (B) to the cabinet using four bolts
(AA).
Tighten all bolts with the 10 mm wrench (DD).
□
DD
AA
B
6

1

2
6
CC
B
C
D
DD
BB
G
Do not over tighten the bolts to avoid damage to the finish.
Warning:
Two or more people may be required for this
step due to the weight of the workbench.
Installing the crank handle or crank cap
3
Store the crank handle (K) or crank cap (L) in one of the
drawers when not in use.
NOTE:
Install the crank handle (K) or crank cap (L) into the shaft
□
next to the Husky badge.
K
L

4
Attaching the power strip brackets
□
Attach the power strip brackets (H) to the cabinet using four
bolts (EE).
Tighten all bolts using a screwdriver.
□
Do not over tighten the bolts to avoid damage to the finish.
NOTE: The holes in the cabinet are tapped and do not
require nuts.
□
H
EE