Instructions / Assembly

Operation
HUSKYTOOLS.COM
Locking and unlocking the unit
IMPORTANT : The drawers must be fully closed before
locking / unlocking the unit.
7

2
□
To lock the unit, insert the key (I) into the lock (J) and turn
□
To unlock the unit, insert the key (I) into the lock (J) and
it one quarter turn counterclockwise. Then remove the key.
turn it one quarter turn clockwise. Then remove the key.
To raise the work surface, long press the up button to the
it reaches the desired height or rests back on top of the
To lower the work surface, long press the down button until
The setting is re-adjustable per user’s request.
Adjusting the height of the
wood top work surface
desired height or until it reaches it’s top.
□
□

1
When the wood top is lowered to a certain height, it slows
NOTE:
WARNING: There is no storage in the center tray.
Use front and back trays only for storage. Do not remove items
I
from trays when the wood top if being raised or lowered.
down to prevent pinched hands. And there is still an
interval when fully lowered based on safety considerations.
rolling cabinet.
the preferable heights as M1 or M2, lift the work surface
to the desired height first then long press M1 or M2 button for
□
three seconds until the red lights flash 3 times.
When the light turns to be blue, the setting is done.
M1 & M2 is for memorizing the working height. To memorize
Please contact 1-888-HD-HUSKY for further assistance.
Installing the drawers
□ Pull the slides and slide carrier out until fully extended.
□ Hold the slide on the cabinet while aligning it with
the slide on the drawer.
□
□ Slowly push the drawer until it is fully closed to
engage the slide.
□ Open the drawer and close it to verify proper
operation.
Slightly insert one side and repeat for the other side.

4
Removing the drawers
□ Fully extend and empty the drawer.

3
□ On the slide, lift up the plastic release lever on one slide
and push down the plastic release lever on the other slide.
Gently pull the drawer out so the slides can ride over
the stops.
Please connect with electricity before operation.
□