Use and Care Manual

9 HUSKYTOOLS.com
Please contact 1-888-HD-HUSKY for further assistance.
Maintenance (continued)
Lubricating the jack
□ Use a good grade of lubricating oil on all
moving parts when needed (arm linkages,
front wheels and rear casters).
□ Grease the lifting arm assembly through its
grease tting, using a good grade of multi-
purpose chassis grease.
Storing the jack
□ When the jack is not in use, or when storing
the jack, ALWAYS have the saddle in its lowest
(down) position.
□ Store the jack in a dry location with all wheels
touching the ground on a relatively level
position.
JACK STAND MAINTENANCE
Maintain the jack stands in accordance with the product instructions:
□ When the stand is not in use, the ratchet should be in the fully lowered position.
□ Keep moving parts clean. Make sure the locking mechanism is free of debris.
□ Always keep the jack stand clean and wipe with an oilcloth every two months.
□ Visually inspect before each use of the jack stand by checking for abnormal conditions, such as cracked
welds, leaks, and damaged, loose, or missing parts.
□ Inspect the jack immediately if the device is believed to have been subjected to an abnormal load or shock. It
is recommended that this inspection be made by a manufacturer’s or supplier’s authorized repair facility.
□ Owners and/or operators should be aware that repair of this equipment may require specialized knowledge
and facilities. It is recommended that an annual inspection of the jack stand be made by a manufacturer’s or
supplier’s authorized repair facility and that any defective parts, decals, or safety labels or signs be replaced
with manufacturer’s or supplier’s specied parts. A list of authorized repair facilities is available from the
manufacturer or supplier.
□ Any jack stand that appears to be damaged in any way, is found to be worn or operates abnormally MUST
BE REMOVED FROM SERVICE UNTIL REPAIRED. It is recommended that necessary repairs be made by a
manufacturer’s or supplier’s authorized repair facility if repairs are permitted by the manufacturer or supplier.
□ Because of potential hazards associated with this type of equipment, no alterations shall be made to the
product.
□ Only attachments and/or adaptors supplied by the manufacturer shall be used.