Troubleshooting Guide
When the jack is not in use, or when storing
the jack, ALWAYS have the saddle in its lowest
(down) position.
STORING THE JACK
Store the jack in a dry location with all wheels
touching the ground on a relatively level position.
JACK STAND MAINTENANCE
Maintain the jack stands in accordance with the product instructions:
When the stand is not in use, the ratchet should be in the fully lowered position.
Keep moving parts clean. Make sure the locking mechanism is free of debris.
Always keep the jack stand clean and wipe with an oilcloth every two months.
Visually inspect before each use of the jack stand by checking for abnormal conditions, such
as cracked welds, leaks, and damaged, loose, or missing parts.
Inspect the jack immediately if the device is believed to have been subjected to an abnormal
load or shock. It is recommended that this inspection be made by a manufacturer’s or
supplier’s authorized repair facility.
Owners and/or operators should be aware that repair of this equipment may require
specialized knowledge and facilities. It is recommended that an annual inspection of the jack
stand be made by a manufacturer’s or supplier’s authorized repair facility and that any
defective parts, decals, or safety labels or signs be replaced with manufacturer’s or
supplier’s specied parts. A list of authorized repair facilities is available from the
manufacturer or supplier.
Any jack stand that appears to be damaged in any way, is found to be worn or operates
abnormally MUST BE REMOVED FROM SERVICE UNTIL REPAIRED. It is recommended that
necessary repairs be made by a manufacturer’s or supplier’s authorized repair facility if
repairs are permitted by the manufacturer or supplier.
Because of potential hazards associated with this type of equipment, no alterations shall be
made to the product.
Only attachments and/or adaptors supplied by the manufacturer shall be used.
RUST PREVENTION
Check the ram and pump piston every two months (or sooner, based on usage) for any signs of rust or corrosion.
Clean as needed and wipe down with an oil cloth.