Instructions / Assembly

Assembly
1
Double sided tape assembly
Attach 4 pcs double-sided tape(AA) to the bottom of the Power Station(A) per the diagram.
Pass the power cord plug through the rubber grommet in the rear.
□
□
□
Ensure the wood top of the 46 in. Mobile Workbench is cleaned, dry, and free of any debris before applying the
double sided tape.
Screw assembly
CAUTION: Do not over tighten the screws.
Using a 3/32 in. drill bit, pre-drill the 4 holes into the wood top. Be careful to only drill 1/2 in. deep.
2
□
Pass the power cord through the rubber grommet in the rear.
□
Align the Power Station(A) along the back of the mobile workbench and mark the 4 hole locations with a pen.
□
6
AA
A
A
BB
A
The 46 in. Power Station is designed to t all Husky Mobile Workbenches with wood tops that are minimum 46 in. wide,
including but not limited to the below Models:
• SKU # 1004319517
• SKU # 763089
• SKU # 304959851
• SKU # 1002811059
• SKU # 309057460
• SKU # 312145948
The 46 in. Power Station can be attached using either the double sided tape or wood screws.
Align the Power Station along the back of the mobile workbench, and rmly stick the power station(A) on cabinet wood top.
□
Secure the Power Station(A) to the wood top using the 4 Self tapping screws(BB).□
• SKU # 1002811059
• SKU # 1004319798
• SKU # 1004337287
• SKU # 311086274
• SKU # 1004319510
• SKU # 1004319798