Instructions / Assembly

Assembly
1
Attaching the cabinet handle
□ Position the cabinet handle (B) over the holes on the
cabinet (A).
□ Attach with the bolts (CC) and tighten with supplied
hex key (DD).
NOTE:
The holes in the cabinet are tapped and do not
require nuts.
6
Attaching the casters
2
□ Be sure the drawers and top lid are locked and lay the
cabinet (A) on its back. Use packaging material to
protect the finish.
□
Attach the swivel casters (D) to the unit, on the same side
as the handle (B), insert bolts (AA) through washers (BB)
and swivel caster (D) into the cabinet (A).
□
Tighten all casters with supplied hex key (DD) or 12 mm
wrench/socket.
□
Repeat this process for the fixed casters (C) on the
opposite side of the cabinet (A).
□
Return the cabinet (A) to its upright position.
CAUTION: Do not over tighten the bolts.
CAUTION:
Two people are recommended for assembly.
AA
CC
B
A
A
C
BB
Attaching the Power tool holder
3
□
□
□
CAUTION: Do not over tighten the bolts.
F
E
CC
Attach both brackets (E) to the Power tool holder (F) using 4 pcs Bolts (CC) and tighten with supplied Hex Key (DD). Figure 3:1.
Position the Power tool holder (F) over the holes on the cabinet (A). Attach with 6 pcs Bolts (CC) and tighten with
supplied Hex Key (DD). Figure 3:2.
Attach both hooks (G) to the Power tool holder (F) using 4 pcs Bolts (CC) and tighten with supplied Hex Key (DD). Figure 3:3.
F
G
CC
CC
F
E
Figure 3:1 Figure 3:2 Figure 3:3