Instructions / Assembly
AIR INLET:
WEIGHT:
MAXIMUM PRESSURE:
PRESSURE RANGE:
1/4 inch NPT
1.38 lb
100 psi
80 psi 100 psi–
PIN SIZE RANGE: 2 inch to 4 inch
FEATURES
SPECIFICATIONS
( 8.8mm)
Max.: 0.346”
( 2.87 - 4.87mm)
0.113”- 0.192”
50mm
100mm
2”
4”
OPERATION
LUBRICATION
Disconnect the air supply from the tool to add lubricant.
This tool requires lubrications before using the tool for the first time and before each use. If an
inline oiler is used, manual lubrication through the air inlet is not required on a daily basis.
⒈
Turn the tool so the air inlet is facing up. Place 4-5 drops of pneumatic fastening tool oil into air inlet.
Do not use detergent oils, oil additives, or air -tool oils. Do not use detergent oil or additives as these
lubricants will cause accelerated wear to the seals and bumpers in the tool, resulting in poor tool
performance and frequent tool maintenance.
2.
3.
After adding oil, run too briefly. Wipe off any
excess oil from the cap exhaust.
CAUTION:
The work surface can become damaged by
excessive lubrication. Proper lubrication is
the owner's responsibility. Failure to
lubricate the tool properly will dramatically
shorten the life of the tool and void your
warranty.
DRIVING A FASTENER
Connect the air supply to the tool.⒈
Load fastener into the palm.
2.
Hold tool with nose pointed toward work surface.
3.
Align fastener and tool in the location where
fastener is to be driven.
4.
Push gently against nail head to drive fastener.
5.
SETTING THE AIR PRESSURE
Continue to apply pressure until fastener is driven completely or until reaching desired penetration.
6.
The amount of air pressure required depends on
the size of the fasteners and the workpiece material.
Begin testing the depth of drive by driving a test nail
into the same type of workpiece material used for
the actual job.
Drive a test fastener with the air pressure set at 90-
95psi. Raise or lower the air pressure to find the
lowest setting that will perform the job with
consistent results.
It may be possible to achieve the desired depth with
air pressure adjustments alone.
MAINTENANCE
Any time inspection, maintenance, and
cleaning are done:
◆Disconnect the tool from the air
resource.
Empty the magazine completely.◆
WARNING:
!
07 08