Full Product Manual

16
17
Hold tool with nose pointed toward work surface.
Align fastener and tool in the location where fastener is to
be driven.
Push gently against nail head to drive fastener.
Continue to apply pressure until fastener is driven
completely or until reaching desired penetration.
Setting the air pressure
3
The amount of air pressure requir ed depends on the size
of the fasteners and the workpiece material
Begin testing the depth of drive by driving a test nail into
the same type of workpiece material used for the actual
job
Drive a test fastener with the air pressur e set at 90-95 psi
Raise or lower the air pressur e to find the lowest setting
that will perform the job with consistent r esults
It may be possible to achieve the desired depth with air
pressur e adjustments alone
.
.
.
.
.
Maintenance
WARNING: Any time inspection, maintenance, and
cleaning are done:
Disconnect the tool fr om the air source.
Empty the magazine completely.
ANTI-DUST CAP
Each tool is packed with an anti-dust cap on the air
connector, check it after unpacking.
Keep the anti-dust cap covering the air connector when
the tool is not in use.
LUBRICATION
Lubrication is requir ed for best performance after long
periods use Oil for pneumatic fastening tools is added
through the air line connection and will lubricate internal
parts Do not use detergent oil or additives as these
lubricants will cause accelerated wear to the seals and
bumpers in the tool resulting in poor tool performance and
frequent tool maintenance
.
.
,
.
CAUTION: Lubricate tool only with specified
lubricants.
Operation(Continued)-(Model#HDPMPN)
CLEANING
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and maybe damaged by their use. Use
clean cloths to remove dirts, dust, oil, grease, etc.
WARNING: Do not at any time let brake fluids,
gasoline, petroleum-based products, penetration oils,
ect. come in contact with plastic parts. Chemicals
can damage, weaken or destroy plastic which may
result in serious personal injury.
For cold weather operation, near and below freezing, the
moisture in the air line may fr eeze and prevent tool
operation. We r ecommend the use of air tool lubricant or
permanent antifreeze (ethylene glycol) as a cold weather
lubricant.
CAUTION: Do not store tools in a cold weather
environment to pr event frost or ice formation on the
tool’s operating valves and mechanisms that could
cause tool failur e.
COLD WEATHER OPERATION
Disconnect the air supply fr om the tool to add lubricant.
Turn the tool so the air inlet is facing up. Place 2 - 3 drops
of pneumatic fastening tool oil into air inlet. Do not use
detergent oils, oil additives, or air -tool oils as these
lubricants will cause accelerated wear to the seals and
bumpers in the tool r esulting in poor tool performance
and fr equent tool maintenance
,
.
2.
1.
After adding oil, connect the tool to the air source run
tool briefly. Wipe off any excess oil from the cap exhaust.
,
3.
CAUTION: The work surface can become damaged by
excessive lubrication. Proper lubrication is the owner's
responsibility . Failure to lubricate the tool properly will
dramatically shorten the life of the tool and void your
warranty .
Please contact 1-888-HD-HUSKY for further assistance.
HUSKYTOOLS.COM