Full Product Manual

Figure 1
Unloading fasteners
2
10
11
Operation(Model#DPFR2190)
Loading fasteners
1
MAXIMUM
LOAD
Nail Hold
Back Spring
Connect the tool to the air source
Insert strip of fasteners from the rear of magazine (A). Be
sure the fasteners ar e pointed downward.
(See figur e 1 & figure 2)
This tool uses a spring loaded bypass lever in order to
load and upload the nails. Once the nails are properly
inserted, pull the pusher (B) completely back, pressing
against the bypass lever of the pusher. (See figure 3)
Once the pusher hits the back of magazine, allow the
pusher to slide forward and engage the nails, pushing
them to the nose of the tool. (See figure 4).
.
Head of nail
Rear of magazine(A)
INSERT NAIL STRIP
Press
bypass lever
Pusher(B)
SLIDE BACK
ENGAGE NAILS
SLIDE FORWARD
WARNING: The tool may fire when it is first connected
to the air source Always connect the tool to the air
source before loading fasteners to prevent injury from
unintended cycling Always make sure the tool s
magazine is empty at the beginning of each work
session before connecting to an air source
.
.'
,.
WARNING: Use only those fasteners recommended
for use with this tool Fasteners not identified for use
with this tool by the tool manufacturer are able to
result in a risk of injury to persons or tool damage
when used in this tool.
.
WARNING: Keep the tool pointed away from yourself
and others when loading fasteners Failure to do so
could result in possible serious personal injury
.
.
WARNING: Never load fasteners with the workpiece
contact or trigger activated Doing so could r esult in
possible serious personal injury
.
.
Press
bypass lever
SLIDE FORWARD
Disconnect the tool from air source.
Pull back the pusher, pressing bypass lever of the pusher
to allow pusher to bypass nails and slowly allow pusher
to r eturn to nose of the tool. (See figure 5)
Slide the fastener to the r ear magazine. Once the nails
have slid back to the hold back spring, press the tab on
the hold back spring to push the spring back and allow
the nails to come out of the magazine. (See figure 6)
PRESS the nail hold back spring
RELEASE
NAILS
WARNING: Always unload all fasteners before
removing tool from service.
WARNING: Always disconnect the air source before
unloading.
Clearing jams
3
Occasionally a fastener may become jammed in the firing
mechanism of the tool making the tool inoperable To
remove a jammed fastener follow the steps below
,
,.
,:
Disconnect the tool from air source
Remove fasteners from the tool Failure to do so will
cause the fasteners to eject from the front of the tool
Pull the jammed fastener out from the nose use pliers or
ascrewdriverifrequiredtoclearthejammedfastener
Using caution not to bend or damage the driver blade
Reconnect the tool to the air source
Reload the tool with fasteners
.
.
.
,
.
.
.
.
WARNING: Make sure there is no fastener in magazine
before clearing a jam.
WARNING: Disconnect the tool from the air source
whenever clearing a jam After disconnecting the tool
from the air compr essor ther e should still be enough
air pressur e to fire the tool After the air hose is
disconnected always fire the tool into scrap wood
repeatedly to make sure all of the compressed air is
expended
.
,
.
,
.
Operation(Continued)-(Model#DPFR2190)
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Please contact 1-888-HD-HUSKY for further assistance.
HUSKYTOOLS.COM