Owner's Manual

GENERAL TECHNICAL DATA
Husky Corporation • 2325 Husky Way • Pacic, MO 63069 • Phone: [phone] • Fax: [phone] • www.husky.com
Page 3 009218-6 9/2011
1. Activate dispenser.
2. Insert spout into ll pipe opening.
3. Lower hose end of nozzle so the vapor recovery sleeve catches the inside of the ll pipe.
4. Raise the lever and begin fueling.
5. Nozzle will shut off automatically when the tank is full.
6. Wait 15 seconds to allow any fuel remaining in the spout to drain.
7. Remove nozzle from ll pipe by raising hose end of the nozzle.
8. Return nozzle to nozzle boot.
NOTE: Nozzle is equipped with a unique Flo-Stop™ device that shuts off the nozzle if it falls from ll pipe or raises above horizontal.
OPERATION INSTRUCTIONS
Nozzle keeps shutting off or won't dispense... 1. Make sure dispenser is on and activated.
2. Slow down ow rate - use lower notch on
clip.
3. Clean spout tip end.
4. Clean or replace lter.
5. Inspect Safe-T-Break
®
.
6. Replace spout assembly.
7. Check dispenser pressure - 19 psi / 1.3 bar
required to activate nozzle.
Nozzle won't shut off... 1. Check ow rate - minimum of 3 gpm /
11.4 Lpm required.
2. Remove nozzle and drain hose.
Nozzle leaking... 1. Check for loose spout.
2. Check inner hose for leaks.
3. Check for cracks in nozzle and hose
threads.
4. Check o-rings on inner hose at nozzle
inlet.
Low ow rate... 1. Remove Flo-Equalizer™ (if equipped).
2. Verify dispenser is not in slow ow rate
mode.
3. Check for system leak.
Flow rate above 10 gpm / 37.9 Lpm... 1. Verify Flo-Equalizer™ being used - either
inside or outside dispenser.
2. Check Flo-Equalizer™ for debris.
Fails pressure decay test... 1. Replace nozzle if leak is greater than 3
cubic inches per minute.
Fuel in vapor side... 1. Check for meter creep.
2. Check o-rings on inner hose.
TROUBLESHOOTING GUIDE
Fuel Type Gasoline and Diesel fuel
Flow Rate Unleaded w/o Flo-Equalizer™ = 10 gpm / 37.9 Lpm
Body Die cast aluminum
Disc Fluorocarbon
Packing Double o-ring seal protected by ber reinforced Teon
Lever One piece contoured steel with hard plastic cover
Shipping Weight 4.0 lbs / 1.8 kg
Threads M34 x 1.5
Spout Unlead = 13/16" / 20.6 mm O.D. with Coaxial Sleeve
Case Quantity 15
Listings (pending) (pending)