Instructions / Assembly

Process:

• Place (1) leveling foot pad FF and (1) leveling foot pad

GG on each side at the bottom. Make sure each leveling

foot is fully seated on each corner.

• Secure each Leveling Foot with (1) bolt AA, (1) Washer

BB and (1) Nut CC.

• Wrench tighten.

• Assemble (1) leveler EE in each leveling foot. Some

adjustments may be necessary after workbench is in

desired position.

SIDE CONSTRUCTION

Items Needed:

A - Side (Qty: 2)

AA - 1/4-20 x 5/8in Carriage Bolt (Qty: 4)

BB - 5/16in Washer (Qty: 4)

CC - 1/4-20 Flange Nut (Qty: 4)

EE - Screw Leveler (Qty: 4)

FF - Leveling Foot, Left (Qty: 2)

GG - Leveling Foot, Right (Qty: 2)

Items Needed:

B - Rail - Top Back (Qty: 1)

D - Rail - Top Front (Qty: 1)

AA - 1/4-20 x 5/8in Carriage Bolt (Qty: 8)

BB - 5/16 Washer (Qty: 8)

CC - 1/4-20 Serrated Flange Nut (Qty: 8)

ASSEMBLY

Figure 1

Figure 2

Process:

• Place Workbench Top, with stainless steel side facing

down. (Use packaging material to prevent scratches.)

NOTE: The Rail with the Husky® nameplate should be

placed toward the front of the unit with the nameplate

position upside down.

• Assemble (2) sides A and rails B and D, as shown using

(8) bolts AA, (8) washer BB, and (8) nut CC. Holes on

rails should be facing to the outside of the workbench top.

• Finger tighten.

TOP RAIL ASSEMBLY

Holes

facing out

Back

Front

Leveler

(on top)