Instructions / Assembly
5 HUSKYTOOLS.COM
Please contact 1-888-HD-HUSKY for further assistance.
Installation
1
Select the location for your Husky Track Wall Panels
□ Both the left and right sides of Husky Track Wall Panels should fasten into studs.
□ Husky Track Wall Panels are 48.5 in. height (when assembled). Select the desired elevation at which to begin assembly of your
Husky Track wall Panels and mark a horizontal level line at which to start from the bottom.
NOTE: In order to support 75lbs per square
foot, your studs must be a maximum of 16in.apart.
2
Locate and mark studs
□ Once you have chosen your installation location,
verify that you are starting and nishing on a stud.
□ Using a stud nder, locate all studs between start and
nish, and mark along their length with a level. You will
need to screw each panel into each stud.
3
Fasten horizontal J-trim to the wall
NOTE: For this step, it is best to have the help
of a second person.
□ Use snips to cut one J-trim (B) to a lengh of 96 in.
□ Install the bottom horizontal 96 in. J-trim where you
marked your level line, using screws (BB), fastening the
widest edge to the wall. Do not fasten into the rst or last
stud..
?
?
front sid
e
wall side
96 in.
x 5
16in.
48.5 in.
96 in.
B J-trim