Instructions / Assembly

Locking the Unit:

• Insert the key and turn fully to the left.

• Remove key.

Unlocking the Unit:

• Insert the key and turn fully to the right.

• Remove key.

LOCKING AND UNLOCKING THE UNIT

Leveling Foot Adjustment

• Adjust Screw Leveler to desired position with Flathead

Screwdriver or 7/16in open end wrench as shown.

Ball bearing slide - Pull slides and slide carrier out to fully

extended position (see illustration.) Hold the slide on the

cabinet while aligning it with the slide on drawer. Slightly

insert one side and repeat for the other side. Slowly push

drawer to its fully closed position to engage slide. Open

drawer and reclose to ensure proper operation.

INSTALLING DRAWERS

slide carrier

slide

Tab Style - Depress the release tabs on both sides,

(this allows the slides to ride over the stops.)

Pull out to remove.

REMOVING AND INSTALLING SLIDES FROM UNIT

• First remove the drawer. (See section A)

To remove the slide

• Push slide to the closed position.

• Insert at tip screw driver between slide and unit,

behind rear rectangular cutout.(See illustration.)

• Rotate screw driver 1/4 turn to force slide away

from unit.

• Push on front of slide pushing it towards back

of the unit.

To attach the slide:

• Extend slide and locate lances within respective

cutout in carrier.

• Pull slide forward until slide locks back into place.

• Reinstall drawer following drawer installation

procedure.(See section B)