Use and Care Manual

5 HUSKYTOOLS.com
Please contact 1-888-HD-HUSKY for further assistance.
Installation
1
Installing the automatic
electronic tank drain
DANGER: This product is specifically designed for
compressed air service only.
WARNING: Always turn the compressor OFF, disconnect
from power source, and drain all pressure from the system
before servicing.
WARNING: RISK OF INJURY - DO NOT install the
electronic tank drain until all pressure has been drained
from the tank and the power to the unit has been
disconnected.
NOTE: Do not allow condensate to freeze in the tank and
drain valve.
NOTE: These products are designed specifically for
compressed air service only.
NOTE:
Dispose of condensate in accordance with local,
state or federal guidelines.
□ Start threading the two screws (I) into the
bracket (F).
□ Install the bracket (F) onto the bottom of the
electronic automatic tank drain assembly (B)
with washers (H) and screws (G). Tighten using
an adjustable wrench.
□ Remove the existing petcock from the bottom
of the tank using an adjustable wrench.
CAUTION: Make sure the air system is drained to zero “0”
before removing petcock and before installing the flexible
drain tube.
NOTE: Use thread sealer or Teflon
®
on all male threads.
□ Install the elbow end of the flexible drain tube
(J) into the bottom of the tank. Tighten using
and adjustable wrench.
□ Attach the strainer ball valve (C) to the back of
the electronic automatic tank drain assembly
(B). Tighten using an adjustable wrench.
□ Attach the straight swivel end of the flexible
drain tube (A) into the end of the strainer ball
valve (C). Tighten using an adjustable wrench.
□ Attach the clear drain hose assembly (E) to
the electronic automatic drain assembly (B).
Tighten using an adjustable wrench.
□ Attach the bracket (F) of the bracket assembly
(L) to the bottom of the tank according to
examples in figures 1-4. Tighten screws
securely using a 3/16 in. allen wrench.
□ Supply the electronic automatic tank drain with
the proper electrical supply voltage.
TYPICAL INSTALLATION
Fig 1 Fig 4Fig 3Fig 2
Formed Feet Channel Feet
Ring Base 1
Ring Base 2
L
L
L
L