User Manual
9980 Installation Instructions Front_Back
05/01/2014
CARE AND USE INSTRUCTIONS
Thank you for selecting a WeatherBeater™ Floor Liner from Winfield Consumer Products. Your new front
floor liners are custom molded to fit your Subaru vehicle. The liners are made to take the place of your factory
floor mats. For correct fit, it is necessary to remove the factory floor mats before installing your new floor
liners. However, do not remove the factory-installed carpeting.
Your liners are made from an engineering resin that is lightweight and extremely tough and durable. The
easiest way to clean your liners is with a damp cloth or sponge. If using a cleaner, 409
®
or Glass Plus
®
work
well. Use of Armor All
®
, Son-of-a-Gun
®
or similar items is discouraged as these products make the liners slick.
INSTALLATION INSTRUCTIONS FOR YOUR SUBARU IMPREZA /
SUBARU WRX / SUBARU XV CROSSTREK FRONT FLOOR LINERS
TO EASE INSTALLATION OF YOUR FRONT FLOOR LINERS, FIRST SLIDE BOTH FRONT ROW SEATS ALL
THE WAY BACK TO ALLOW THE MOST LEG ROOM. NOTE: INSTALL THE DRIVER’S SIDE LINER MAKING
SURE TO SECURE IT WITH THE FACTORY CARPET MAT RETAINING POSTS (POSTS FIT THROUGH HOLES
IN LINER). ONCE LINERS ARE INSTALLED, REPOSITION THE SEATS AS DESIRED.
YOUR DRIVER’S SIDE LINER IS DESIGNED TO COVER THE FUEL DOOR RELEASE. TO ACCESS THE
RELEASE LEVER YOU CAN SIMPLY LIFT THE REAR OF THE LINER OR, YOU CAN TRIM AWAY THE
MATERIAL ABOVE THE LEVER AS SHOWN ABOVE. THE AREA TO BE TRIMMED IS LOWERED IN THE
LEFT OR DRIVER’S SIDE
RIGHT OR PASSENGER’S SIDE


