User Guide

9230 Insert X 2.doc

12/30/02

CARPET LINER INSTALLATION INSTRUCTIONS

Your new 3D® Carpet Liners are designed to be held firmly in place with a Velcro® anchoring system. You will

find that each of your front liners come with two Velcro® “hook” patches applied to the underneath surface of the

liners. In the hardware bag included in the shipping container you will find 4 anchor screws with the “loop” portion

of the Velcro® applied. The anchor screws will need to be installed in your factory carpet directly beneath the

Velcro® hook patches to hold the liners in place. The anchor screws will not damage your carpet and can easily be

removed if necessary.

To align the anchors with the patches on the liner, first place your liner in the vehicle, adjusting it to the proper fit.

Then, pull up a corner of your liner as shown in the photo below and attach the anchor screw to the Velcro® pad on

the liner. Lower the raised edge and note the position where the anchor screw touches the vehicle carpet. There are

many ways to mark this location; here are a couple of suggestions:

•Apply a 1” strip of masking tape directly to the carpet underneath the anchor screw. When the anchor screw is

lowered, it will pierce the tape and mark the location.

•Insert a straight pin (needle) next to the point where the anchor screw contacts the carpet to mark the screw

location.

Removal of the factory carpet hook is recommended. The carpet hook can be removed using a screwdriver

to release them. Use a flat wide blade screwdriver, sliding it under the front edge of the clip. Carefully apply

pressure and twist to release the clip (pushing from the firewall towards the seat).

With screw secured in carpet, align Velcro®

halves to secure liner in place.

Anchor screw will pierce masking

tape, marking screw location.

Anchor screw shown attached to

Velcro® Dot on back of liner.