Installation Manual

Page 3
7912INS_R1
6. Tuck the remaining portion of the Wheel
Well Guard behind the fender lip all the way
around the fender well opening.
Note: Make sure on ared models the Wheel
Well Guard lip is tucked behind the metal
wheel well lip of the truck
7. Align the holes in the Wheel Well Guard at
locations B and C with the factory screw loca-
tions with the U-clips and install the #10 SEM
screws using a phillips head screwdriver.
Note: Do not tighten screws all the way till all
fasteners are installed
8. At locations A and D install the #10 SEM
screws through the Wheel Well Guard and the
slotted factory hole and into a U-clip on the
backside of the sheet metal.
Note: The U-clip goes on the back side of the
sheet metal and is used as a nut at both loca-
tions A and D.
9. Once all fasteners at locations A,B,C & D are
installed, tighten with a phillips head
screwdriver
10. Repeat steps 1-9 on the other side of the
vehicle.