Installation Manual

ManualsBrandsHusky Liners ManualsAutomotiveHusky Liners 79121 Rear Wheel Well Guards Fits 15-18 F150 (Will NOT fit Raptor)

Page 1 7912INS_R1

Wheel Well Guards

79121 - Installation Instructions

Ford F150

PACKAGE CONTENTS:

Wheel Well Guard

Driver’s Side (1)

Wheel Well Guard

Passenger’s Side (1)

TOOLS REQUIRED:

• Phillips Head Screwdriver

B C

VEHICLE PREPARATION:

Your vehicle’s rear fender wells should be

cleaned prior to the installation of your

new Husky Wheel Well Guards.

Installation

Read all directions thoroughly prior to the

installation of your Wheel Well Guards.

A, B, C & D are pre-drilled fastener locations for

installation.

1. Check part number on the top of the Wheel

Well Guard and identify DS & PS to determine

which side to install.

• DS 7912 installs on the driver’s side.

• PS 7912 installs on the passenger’s side.

8 - #10 SEM Screws

8 - U-Clips

Summary of content (4 pages)

PAGE 1
Wheel Well Guards 79121 - Installation Instructions Ford F150 PACKAGE CONTENTS: 8 - #10 SEM Screws 8 - U-Clips Wheel Well Guard Driver’s Side (1) Wheel Well Guard Passenger’s Side (1) TOOLS REQUIRED: • VEHICLE PREPARATION: Phillips Head Screwdriver B A Your vehicle’s rear fender wells should be cleaned prior to the installation of your new Husky Wheel Well Guards. Installation C D Read all directions thoroughly prior to the installation of your Wheel Well Guards.
PAGE 2
. Install a u-clip over the factory hole at location B and C. 3. Insert the Wheel Well Guard into the rear wheel well opening over the tire. NOTE: It is not necessary to remove the tire. 4. Push the Wheel Well Guard up into the wheel well opening. 5. Insert the lower flap sections of the Wheel Well Guard into the fender well behind the fender well lip. Perform this step for both the front and rear lower flap sections.
PAGE 3
6. Tuck the remaining portion of the Wheel Well Guard behind the fender lip all the way around the fender well opening. Note: Make sure on flared models the Wheel Well Guard lip is tucked behind the metal wheel well lip of the truck 7. Align the holes in the Wheel Well Guard at locations B and C with the factory screw locations with the U-clips and install the #10 SEM screws using a phillips head screwdriver. Note: Do not tighten screws all the way till all fasteners are installed 8.
PAGE 4
Congratulations, You have now successfully installed your new Husky Liners Wheel Well Guards. If you have any questions please call us at 1-800-344-8759. HUSKY LINERS WHEEL WELL GUARDS LIMITED LIFETIME WARRANTY WINFIELD CONSUMER PRODUCTS WARRANTS YOUR HUSKY LINERS WHEEL WELL GUARD PROTECTION PRODUCT WITH A LIMITED LIFETIME WARRANTY TO THE ORIGINAL PURCHASER.