User Guide

10. Install a #10 SEM screw at location A through the fender sheet
metal, through the Wheel Well Guard and into a U-Clip (see
image below).
NOTE: For F250/350’s WITH factory fender ares - Remove
plastic fastener from vehicle fender location A prior to
installing SEM screw and U-Clip as described in step 10.
11. Do not clip the U-Clip over the Wheel Well Guard.
The U-
Clip functions as a “nut” and is placed on backside of the Wheel
Well Guard at location A.
12. Finish by tightening all fasteners.
Repeat steps 1-12 for the other side of the
vehicle.