User Guide

7. Install #10 SEM screws at locations B and C, through the Wheel
Well Guard and into the pre-drilled sheet metal holes. Leave
screws loose until all fasteners are installed.
8. Install a #10 SEM screw at location D through the under side
sheet metal, through the Wheel Well Guard and into a U-Clip
(see image below).
9. Do not clip the U-Clip over the Wheel Well Guard.
The U-Clip
functions as a “nut” and is placed on top of the Wheel Well
Guard at location D.
6. Push the Wheel Well Guard up until it rests against the inside of
the fender well. Drill 1/8” holes at locations B and C.
NOTE: Make sure that sheet metal is visible through Wheel
Well Guard holes B and C prior to drilling.