Installation Manual

PART NO. 5944

5944 Front Instructions (2 SIDED DOC)F

Rev: 0

FORD F150

WITHOUT FENDER FLARES

REAR MUD GUARD INSTALLATION INSTRUCTIONS

Install Paint Protection Film before mud guards (see other side)

Please read instructions thoroughly before installation.

Tools Required

• 1/8” drill bit / Drill

• Short #2 Phillips screwdriver

• Center punch

Package Contents

• Driver & passenger side rear mud guard

• #10 SEM screw (qty. 6)

• U-clip (qty. 4)

• Spring Clip (qty. 2)

• Paint Protection Film (1 set)

• Instruction sheet

NOTE: Turn the front wheels all the way to the left or right for mud guard installation. However, it may be necessary

to remove the wheels depending on the tools being used for installation.

Determine which mudguard you have by locating the part number molded in the mounting flange

(5944 LH 5944 RH).

Clean and degrease the mud guard location area on the fender before installation.

2. Remove existing fasteners from location B and C and discard.

3. Peel red protective cover from the 3M adhesive on the mudguard.

4. Attach mud guard to front fender with the #10 SEM screws at location B and C, check fit and make sure mud

guard is parallel to ground before tightening. Be sure to press firmly on the area with the 3M adhesive tape to

make sure adhesive is set.

5. Install the spring clip at the tic mark locations located near the top of the part.

OPTIONAL FASTENER INSTALLATION

6. Using the mud guard as a template mark, center punch and drill 1/8” holes at location A.

7. Install #10 SEM screw through the mudguard and sheet metal

PAINTING INSTRUCTIONS

Note: If painting mud guards, perform a mud guard test fit to ensure correct fit and application prior to painting.

1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.

2. Sand painting surface with 320 grit sand paper.

3. Apply a coating of flexible primer-adhesion promoter.

4. Apply a flexible paint as directed by the paint manufacturer.