User Guide

PART NO. 5770
5770 Rear Instruction#109BC.doc
Rev: 0
CHEVROLET / GMC COLORADO / CANYON
WITHOUT FENDER FLARES
REAR MUD GUARD INSTALLATION INSTRUCTIONS
Install Paint Protection Film before mud guards (see other side)
Please read instructions thoroughly before installation.
Tools Required
• 1/8” drill bit / Drill
• Short #2 Phillips screwdriver
• Center punch
Package Contents
• Driver & passenger side rear mud guard
• #10 screw (qty. 8)
• Washers (qty. 8)
• U-Clip (qty. 2)
• Paint Protection Film (1 set)
• Instruction sheet
NOTE: It may be necessary to remove the rear wheels for mud guard installation.
1. Clean and degrease the mud guard location area on the fender before installation.
2. Install u-clip over sheet metal at location D and align with existing hole (Figure 1).
3. Attach mud guard with #10 screw and washer at location D, check fit and make sure the mud guard is parallel to
the ground before tightening.
4. Using the mud guard as a template, center punch and drill 1/8” holes at locations A, B, and C (Figure 1).
5. Install #10 screws and washers at locations A, B, and C.
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer.