User Guide

PART NO. 5761
5761 Ford Explorer 06#7D6BB.doc
Rev: 0
FORD EXPLORER REAR MUD GUARDS
INSTALLATION INSTRUCTIONS
Install Paint Protection Film before mud guards (see other side)
Please read instructions thoroughly before installation.
Tools Required
• 1/8” drill bit / Drill
• Center punch / Hammer
• Short Phillips screwdriver or drill attachment
Package Contents
• Driver & passenger side rear mud guard
• #10 screw (qty. 8)
• Washers (qty. 8)
• U-clip (qty. 4)
• Paint Protection Film (1 set)
• Instruction sheet
NOTE: It may be necessary to remove the wheels depending on the tools being used for installation.
1. Clean and degrease the mud guard location area on the fender before installation.
2. Remove existing fastener from location B and install u-clip over fender (Figure 1).
3. Attach mud guard to rear fender with a #10 screw and washer, thru mud guard, fender and into U-clip. Check fit and level before
tightening.
4. Using mud guard as a template, mark and drill 1/8” holes at locations A, C, and D.
5. Install #10 screws and washers at locations A and B (Figure 1).
6. Install #10 screw and washer at location D, thru mud guard, fender liner and into a U-clip placed on the backside of fender liner
(Figure 2).
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer.