User Guide

PART NO. 5760
5760 Rear Instruction#1170A.doc
Rev: 0
FORD F-150 without FENDER FLARES
REAR MUD GUARD INSTALLATION INSTRUCTIONS
Install Paint Protection Film before mud guards (see other side)
Please read instructions thoroughly before installation.
Tools Required
• 1/8” drill bit / Drill
• Short #2 Phillips screwdriver
• Center punch
Package Contents
• Driver & passenger side rear mud guard
• #10 screw (qty. 6)
• Washers (qty. 6)
• U-Clip (qty. 4)
• Paint Protection Film (1 set)
• Instruction sheet
NOTE: It may be necessary to remove the rear wheels for mud guard installation.
1. Clean and degrease the mud guard location area on the fender before installation.
2. Remove factory plastic fasteners from locations B and C (Figure 1).
3. Place U-clips over sheet metal and align fastener and U-clip holes at locations B and C (Figure 1).
4. Attach mud guard with #10 screws and washers at locations B and C, check fit and make sure the mud guard is
parallel to the ground before tightening.
5. Using the mud guard as a template, center punch and drill an 1/8” hole at location A (Figure 1).
6. Install #10 screw and washer at location.
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer.