User Guide

PART NO. 5752
5752RE~1.DOC
Rev: 0
97-01 FORD EXPEDITION XLT WITHOUT FENDER FLARES
REAR MUD GUARD INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
Tools Required
• 1/8” drill bit / Drill
• Short #2 Phillips screwdriver
• Center punch
Package Contents
• Driver & passenger side rear mud guard
• #10 screw (qty. 6)
• Instruction sheet
NOTE: It may be necessary to remove the rear wheels for mud guard installation.
1. Clean and degrease the mud guard location area on the fender before installation.
2. Remove factory fastener from locations B and C (see below).
3. Attach mud guard to rear fender with the factory fastener at location B and C, check fit and alignment. Adjust accordingly
before tightening.
4. Using the mud guard as a template, center punch and drill 1/8” hole at locations A, D, and E (see below).
5. Install #10 screws at location A, D, and E.
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer.