User Guide

PART NO. 5737
5737 Rear Instructions.doc
Rev: 0
2003 CHEVROLET TRAILBLAZER REAR MUD GUARD SET
REAR MUD GUARD INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
Tools Required:
• 1/8” drill bit / Drill
• Center punch / Hammer
• Short Phillips screwdriver
• Marking utensil (fine tip marker, grease pencil, etc.)
Package Contents
• Driver & passenger side mud guard
• 1” #10 screws (qty. 6)
• Instruction sheet
NOTE: It may be necessary to remove the wheels depending on the tools being used for installation.
1. Clean and degrease the mud guard location area on the fender before installation.
2. Remove existing fastener from location B (see Figure 1).
3. Attach mud guard to fender with existing fastener at location B, check to make sure mud guard is evenly covering
tire and is parallel to the ground (see Figure 1).
4. Using mud guard as a template, mark, center punch, and drill 1/8” holes at locations A, C & D (Figure 1).
5. Attach mud guard to fender with 1” #10 screws at locations A, C, & D.
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer