User Guide

PART NO. 5730
5730 Rear Instructions.doc
Rev: 0
PAINT PROTECTION FILM - INSTALLATION INSTRUCTIONS
NOTE: The Paint Protection Film is a precut template of film used to protect the mud guard mounting
surfaces of your fenders against wear. The templates (left and right side) can be removed from the
backing liner by folding the liner at the center cut of the template, separating the film sides and peeling
the film templates from the backing liner.
1. Position mud guard on fender to indicate placement of paint protection film.
2. Clean the placement area of fender with a clean cotton cloth and a petroleum distillate based cleaner
such as DuPonts Prep-Sol Brand Solvent Cleaner or 3M Brand Adhesive Cleaner and dry.
3. Mix a wetting solution of 1 pint of water with 4 drops of liquid dishwashing detergent.
4. Mark correct position of film by placing mud guard against fender.
5. Remove protection film from liner and flood adhesive side of film with wetting solution (use a spray bottle
or sponge).
6. Thoroughly wet film placement location of fender with wetting solution.
7. Position the adhesive side of film on fender and flood with wetting solution.
8. Check location of film with mud guard and reposition as necessary.
9. Using a sponge, squeegee any air bubbles and wrinkles from film.
10. Allow film to dry before installing mud guard.