User Guide

PART NO. 5707

5707 Rear Instructions.doc

Rev: 0

2003 DODGE RAM DUALLY REAR MUD GUARD

INSTALLATION INSTRUCTIONS

Install Paint Protection Film before mud guards (see other side)

Please read instructions thoroughly before installation.

Tools Required

• Short Phillips screwdriver

• Center punch

• Drill / 1/8” drill bit

Package Contents

• Driver & passenger side rear mud guard

• #10 screw (qty. 4)

• Washers (qty. 4)

• Paint Protection Film (1 set)

• Instruction sheet

NOTE: It may be necessary to remove the rear wheels depending on the tools being used for installation.

1. Clean and degrease the mud guard location area on the fender before installation.

2. Remove existing fasteners from locations A and C (Figures 1).

3. Attach mud guard at locations A and C with existing fasteners, check fit and level before tightening.

4. Using mud guard as a template, mark, center punch, and drill 1/8” holes at locations B and C and attach with a #10

screw (Figure 1).

PAINTING INSTRUCTIONS

1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.

2. Sand painting surface with 320 grit sand paper.

3. Apply a coating of flexible primer-adhesion promoter.

4. Apply a flexible paint as directed by the paint manufacturer.

PAGE 1
PART NO. 5707 2003 DODGE RAM DUALLY REAR MUD GUARD INSTALLATION INSTRUCTIONS Install Paint Protection Film before mud guards (see other side) Please read instructions thoroughly before installation. Tools Required • Short Phillips screwdriver • • Center punch • • Drill / 1/8” drill bit • • • Package Contents Driver & passenger side rear mud guard #10 screw (qty. 4) Washers (qty.
PAGE 2
PART NO. 5707 PAINT PROTECTION FILM - INSTALLATION INSTRUCTIONS NOTE: The Paint Protection Film is a precut template of film used to protect the mud guard mounting surfaces of your fenders against wear. The templates (left and right side) can be removed from the backing liner by folding the liner at the center cut of the template, separating the film sides and peeling the film templates from the backing liner. 1. Position mud guard on fender to indicate placement location of paint protection film. 2.