User Guide

PART NO. 5654

5654 Front Instructio#1170D.doc

Rev: 1

FORD EXPEDITION WITH FENDER FLARES

FRONT MUD GUARD INSTALLATION INSTRUCTIONS

Install Paint Protection Film before mud guards (see other side)

Please read instructions thoroughly before installation.

Tools Required:

• 1/8” drill bit / Drill

• Short Phillips screwdriver

• Center punch

Package Contents

• Driver & passenger side mud guard

• #10 screw (qty. 6)

• Paint Protection Film (1 set)

• Instruction sheet

NOTE: Turn the front wheels all the way to the left or right for mud guard installation. However, it may be necessary

to remove the wheels depending on the tools being used for installation.

1. Clean and degrease the mud guard location area on the fender before installation.

2. Remove factory fasteners from location B (see figure 1).

3. Attach mud guard to front fender with the factory fasteners at location B, check fit and alignment. Adjust

accordingly before tightening.

4. Using the mud guard as a template, center punch, drill 1/8” holes at locations A, C, and D.

5. Install mud guard with #10 screws at locations A, C, and D.

PAINTING INSTRUCTIONS

1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.

2. Sand painting surface with 320 grit sand paper.

3. Apply a coating of flexible primer-adhesion promoter.

4. Apply a flexible paint as directed by the paint manufacturer.

PAGE 1
PART NO. 5654 FORD EXPEDITION WITH FENDER FLARES FRONT MUD GUARD INSTALLATION INSTRUCTIONS Install Paint Protection Film before mud guards (see other side) Please read instructions thoroughly before installation. Tools Required: • 1/8” drill bit / Drill • Short Phillips screwdriver • Center punch • • • • Package Contents Driver & passenger side mud guard #10 screw (qty.
PAGE 2
PART NO. 5654 PAINT PROTECTION FILM - INSTALLATION INSTRUCTIONS NOTE: The Paint Protection Film is a precut template of film used to protect the mud guard mounting surfaces of your fenders against wear. The templates (left and right side) can be removed from the backing liner by folding the liner at the center cut of the template, separating the film sides and peeling the film templates from the backing liner. 1. Position mud guard on fender to indicate placement location of paint protection film. 2.