User Guide

PART NO. 5651
5651 Front Instructions.doc
Rev: 1
2003 FORD SUPER DUTY KING RANCH FRONT MUD GUARD
INSTALLATION INSTRUCTIONS
Install Paint Protection Film before mud guards (see other side)
Please read instructions thoroughly before installation.
Tools Required
• 1/8” drill bit / Drill
• Short #2 Phillips screwdriver
• Center punch
Package Contents
• Driver & passenger side rear mud guard
• #10 screw (qty. 6)
• Paint Protection Film (1 set)
• Instruction sheet
NOTE: Turn the front wheels all the way to the left or right for mud guard installation. However, it may be necessary
to remove the wheels depending on the tools being used for installation.
1. Clean and degrease the mud guard location area on the fender before installation.
2. Remove factory fastener from locations B (Figure 1).
3. Attach mud guard to front fender with the factory fastener at location B, check fit and make sure mud guard is
parallel to ground before tightening.
4. Using the mud guard as a template, center punch and drill an 1/8” hole at location A, C and D (Figure 1).
5. Install a #10 screw at location A, C and D.
NOTE: ONE OF THE MUD GUARD HOLES WILL NOT BE USED (Figure 1).
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer.