User Guide

PART NO. 5644

5644 Front Instructions.doc

Rev: 0

2002 EXPLORER WITH CLADDING FRONT MUD GUARD SET

FRONT MUD GUARD INSTALLATION INSTRUCTIONS

Please read instructions thoroughly before installation.

Tools Required:

• 1/8” drill bit / Drill

• Center punch / Hammer

• Short Phillips screwdriver

• Marking utensil (fine tip marker, grease pencil, etc.)

Package Contents

• Driver & passenger side mud guard

• #10 screws (qty. 6)

• Instruction sheet

NOTE: Turn the front wheels all the way to the left or right for mud guard installation. However, it may be necessary

to remove the wheels depending on the tools being used for installation.

1. Clean and degrease the mud guard location area on the fender before installation.

2. Using mud guard as a template, mark, center punch, and drill 1/8” holes at locations A, B & C (Figure 1).

3. Attach mud guard to fender with 1” #10 screws at locations A, B & C.

PAINTING INSTRUCTIONS

1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.

2. Sand painting surface with 320 grit sand paper.

3. Apply a coating of flexible primer-adhesion promoter.

4. Apply a flexible paint as directed by the paint manufacturer

PAGE 1
PART NO. 5644 2002 EXPLORER WITH CLADDING FRONT MUD GUARD SET FRONT MUD GUARD INSTALLATION INSTRUCTIONS Please read instructions thoroughly before installation. Tools Required: • 1/8” drill bit / Drill • Center punch / Hammer • Short Phillips screwdriver • Marking utensil (fine tip marker, grease pencil, etc.) • • • Package Contents Driver & passenger side mud guard #10 screws (qty. 6) Instruction sheet NOTE: Turn the front wheels all the way to the left or right for mud guard installation.