User Guide

PART NO. 5608

5608 Front Instructions#A04.doc

Rev: 0

DODGE DURANGO

FRONT MUD GUARD INSTALLATION INSTRUCTIONS

Install Paint Protection Film before mud guards (see other side)

Please read instructions thoroughly before installation.

Tools Required

• 1/8” drill bit / Drill

• Short Phillips screwdriver

• Marking utensil (fine tip marker, grease pencil, etc.)

Package Contents

• Driver & passenger side front mud guard

• #10 screw (qty. 8)

• Washer (qty. 8)

• U-clip (qty. 4)

• Paint Protection Film (1 set)

• Instruction sheet

1. Clean and degrease the mud guard location area on the fender before installation.

2. Remove factory fastener from location B, install u-clip over sheet metal and align with factory hole (Figure 1).

3. Attach mud guard with #10 screw and washer at location B.

4. Using the mud guard as a template, mark and drill 1/8” holes at locations A, C, and D.

5. Install #10 screws and washers at locations A and C.

6. Install #10 screw and washer at location D thru mud guard, thru fender liner and into u-clip.

NOTE: U-clip is placed on the backside of fender liner. DO NOT clip over liner.

PAINTING INSTRUCTIONS

1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.

2. Sand painting surface with 320 grit sand paper.

3. Apply a coating of flexible primer-adhesion promoter.

4. Apply a flexible paint as directed by the paint manufacturer.

PAGE 1
PART NO. 5608 DODGE DURANGO FRONT MUD GUARD INSTALLATION INSTRUCTIONS Install Paint Protection Film before mud guards (see other side) Please read instructions thoroughly before installation. Tools Required • 1/8” drill bit / Drill • Short Phillips screwdriver • Marking utensil (fine tip marker, grease pencil, etc.) 1. 2. 3. 4. • • • • • • Package Contents Driver & passenger side front mud guard #10 screw (qty. 8) Washer (qty. 8) U-clip (qty.
PAGE 2
PART NO. 5608 PAINT PROTECTION FILM - INSTALLATION INSTRUCTIONS NOTE: The Paint Protection Film is a precut template of film used to protect the mud guard mounting surfaces of your fenders against wear. The templates (left and right side) can be removed from the backing liner by folding the liner at the center cut of the template, separating the film sides and peeling the film templates from the backing liner. 1. Position mud guard on fender to indicate placement location of paint protection film. 2.