User Guide

PART NO. 5434
5434 Inst
Rev: 0
DODGE RAM LOGO READY REAR MUD GUARDS
REAR MUD GUARD INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
Tools Required
• 1/8” drill bit / Drill
• Short Phillips screwdriver
• Marking utensil (fine tip marker, grease pencil, etc.)
Package Contents
• Driver & passenger side rear mud guard
• #10 screw (qty. 4)
• Washer (qty. 4)
• Instruction sheet
1. Clean the mud guard location area on the fender before installation.
2. Remove factory fastener from location B and attach mud guard to fender with factory fastener (Figure 1).
3. Using the mud guard as a template, mark and drill 1/8” holes at locations A and C.
4. Install #10 screws and washers at locations A and C.
NEED A LOGO FOR YOUR NEW MUD GUARD? TRY AN INTERNET SEARCH FOR
“EMBLEM” ON E-BAY, AMAZON OR YOUR FAVORITE AUTOMOTIVE SITE.