User Guide

47951 Wrangler Tire #140AE2.doc
- 1 -
Jeep Wrangler Spare Tire Carrier Mounting Instructions
Tools Required for Installation: Package Contents (Continued):
Socket Wrench Bumper Pack Contents (Continued)
18 MM Socket Striker Nut Plate
13 MM Socket _” Flat Washers X 5
3/4” Socket Bumper End Plugs
5/8” Socket U-Clips X 6
1/2” Socket #10 X _” Washer Head Screw X 6
18 MM Wrench Bumper Surround Tabs
9/16” Wrench Swing Arm X 1
3/4” Wrench 1/4” X 3/4” Allen bolt X 1
5/8” Wrench 1/4” plastic washer X 1
1/2” Wrench 3/8” X 1/2” fine thread hex bolt X 1
T-30 Torx Wrench 3/8” fender washer X 1
3/16” Allen Wrench Jack Support Upright
Jack and/or Jack Stand Jack Support Spacers (3/4” & 1” Lengths)
Phillips Head Screwdriver 3/8”-16 X 2-1/2" full thread hex bolt X 1
Jack Mount Hand Knob X 2
Package Contents 3/8” flat washer X 2
Bumper X 1 Tire Mount Assembly X 1
Bumper Mount nut plate X 2 Washer Plates Assembly
7/16” X 1” hex bolt X 4 Brake Light Mount X 1
7/16” flat washer X 8 5/16” X 1” hex bolt X 4
7/16” nylock nut X 4 5/16” fender washer X 8
1/2” X 1-1/4” hex bolt X 2 5/16” nylock nut X 4
1/2” X 1-1/2” hex bolt X 3 5/16” plastic washer X 2
Striker Plate/Pin Assembly X 1 Cable Tie Mount X 3 (Use for additional wiring requirements)
Before beginning installation, check to make sure all components listed above are included in packaging.