Installation Guide
7Bathroom Exhaust Fan Installation - English
SERVICE PARTS
1
4
5
d
e
a
2
3
b
c
6
8
7
9
9
10
PART PART NAME Qty.
1 GRILLE 1
2 SPRING 2
3 MOTOR ASSEMBLY 1
4 MOTOR 1
5 BLOWER WHEEL 1
6 WIRE PANEL ASSEMBLY 1
7 WIRE COVER 1
8 HOUSING 1
9 HANGER BARS 4
10 DUCT CONNECTOR 1
a NUTS 4
b GROMMETS 4
c MOTOR BRACKETS 1
d MOTOR MOUNTING PLATE 4
e SCREWS 1
Replacement installation:
Remove the screw (part c), then take out the motor plate (part 3) from
the housing (part 8) by pushing down the rib in the plate while pulling
out on the side of the housing. Replace the broken parts.
WARNING: Ensure that the fan is switched o from the supply mains before replacing.
* Blower Assembly includes part 5, 4, d, 3, c, b, a.
CLEANING & MAINTENANCE
Use an on/o switch to operate this fan. See “Connect Wiring” for details.
OPERATION
For quiet and ecient operation, long life, and attractive appearance - lower or remove grille and vacuum interior of unit with the
dusting brush attachment. e motor is permanently lubricated and never needs oiling. If the motor bearings are making excessive or
unusual noises, replace the motor with the exact service motor. e impeller should also be replaced.