Installation Guide

6 Bathroom Exhaust Fan Installation- English
Step 1: Snap the damper/duct connector onto the fan housing. e connector must
be ush with the top of the housing, and the damper ap should fall closed.
Optional: Insulated exible duct is recommended for the quietest possible installation.
If rigid duct is used, a short (1-3 feet) section of insulated exible duct will ensure
quiet operation.
DUCT
3. INSTALL ROUND DUCTWORK
Step 1: Connect the round ductwork (not included) to the damper/duct connector,
and run the ductwork to a roof or wall cap (not included).
Step 2: Using aluminum tape (not included), secure all the ductwork connections so
that they are air tight.
4. CONNECT ELECTRICAL WIRING
FAN
Wire
Panel
UNIT
BLACK (BLK)
SWITCH BOX
FAN
power supply
120V AC
GROUND (GRD)
WHITE(WHT)
fan
receptacle
• Run 120 V AC house wiring to the location of the fan. Use only UL-approved connectors (not included) to attach the house wiring to the wiring
plate. Refer to the wiring diagram, and connect the wires as shown.
FOR TRUSS MOUNTING
* FOR MODEL CB50, PLEASE READ ADDITIONAL STEPS
Snap-in ans secure housing.
INSTALL GRILLE
Step 1: Install ceiling material to complete the ceiling construction. en, cut around
the fan housing.
Step 2: To attach the grille assembly to the fan housing, pinch the grille springs on
the sides of the grille assembly, and position the grille into the housing with the grille
springs in the appropriate slots.
Step 3: Push the grille assembly towards the ceiling to secure.