Owners manual

!
Remove interior trim, (carpet,
underpad, molding) down to
sheetmetal surface. Remove
loose dirt and dust from
surface.
!
Cut HushMat™ to desired
shape using knife or scissors
prior to removing the paper
liner. Peel off the release liner.
General Installation Instructions
INSTALLATION INSTRUCTIONS
Inner
metal panel
Outer door panel
Cut speaker opening where applicable in HushMat. Apply to
the metal part of the door and to the inside of the outer vinyl
door panel.
Inside of
Outer door panel
DOOR KIT
Inner
metal panel
T r e a t s h a d e d a r e a s
w i t h H u s h M a t
HushMat
Cut speaker opening in HushMat and apply to the speaker area on
the metal part of the door and to the inside of the outer vinyl door
panel.
Inner
metal panel
Inner
metal panel
Outer door panel
SPEAKER KIT
Inside of
Outer door panel
HushMat
T r e a t s h a d e d a r e a s
w i t h H u s h M a t
Kit Specific Installation Instructions
BULK KIT
FLOOR/DASH KIT
Treat shaded areas with HushMat
Remove interior trim, (carpet, underpad, molding) down
to sheetmetal surface. Remove loose dirt and dust from
surface. Use scissors or razor knife to trim HushMat to
desired size. Follow general instructions above.
FloorDash
WHEEL WELLS
TRUNK
FLOOR
TRUNK LID
INTERIOR REAR BUMPER
REAR
QUARTER
PANELS
BACK DECK
Remove interior
trim, (carpet,
underpad, molding)
down to sheetmetal
surface. Remove
loose dirt and dust
from surface. Use
scissors or razor
knife to trim
HushMat to desired
size. Follow general
instructions above.
TRUNK KIT
Also apply HushMat to fiberglass or
other speaker box enclosures to
prevent distortion and vibration
transfer to your vehicle.
Treat shaded
areas with HushMat
TAPE KIT
RMD LLC 9900 Pflumm Road, Unit 11, Lenexa, Kansas USA 66215 Phone [phone] www.hushmat.com913-599-2600 Fax
!
at one side and press across the surface of the
sheet.
!
If the surface is contoured, press the sheet down
into the contours as you press across the surface of
the sheet. This will prevent "bridging" of the sheet.
!
Smooth out the sheet to ensure there is no
entrapped air under the sheet.
Press the HushMat sheet onto the surface starting
Follow general instructions
above. Place tape over wire
harness or cable securing it
to the vehicle or trim
surface. Press tape firmly
into all contoured surfaces
to prevent “bridging.”
LICENSE PLATE KIT
Trim HushMat™ if necessary, to fit
behind your license plate using knife
or scissors prior to removing the paper
liner. Peel off the release liner. Press
firmly to back of plate.
Attach license plate frame using
included foam strip backing.
No Pre-Heating or Pre-Treatment of the surface—or HushMat—required.
HushMat Silver and Black
black PMS 186
(Para evitar que se rasguñe o corte la piel al instalar el material, nosotros
recomendamos el uso de guantes de algodón durante la instalación.)
(To avoid minor cuts and scrapes from material, we recommend the use of
cotton gloves during installation.)