Datasheet

7/18/2019 ROSbot manual · Husarion Docs
https://husarion.com/manuals/rosbot-manual/#rosbot-manual-overview 12/17
2. Download image for Raspberry Pi/Tinkerboard from here (there is a single image for both
platforms).
3. Extract downloaded image (For this process we recommend using 7zip)
4. Flash the extracted image onto SD card (For this process we recommend using Etcher but any
image writing tool will be good):
If you want to replace the included card, remember that you need to use at least 16 GB capacity
and 10 speed class micro SD card.
Download Etcher and install it.
Connect an SD card reader with the SD card inside.
Open Etcher and select from your hard drive .img file that you extracted.
Select the SD card you wish to write your image to.
Review your selections and click 'Flash!' to begin writing data to the SD card.
5. Insert SD card back to ROSbot
6. Proceed to Connecting to Husarion cloud section.
ROSbot 2.0 PRO
Before you begin, you will need:
USB drive (at least 8GB)
Mouse, keyboard and USB hub
Display with HDMI cable
1. Download Ubuntu 16.04 installation image from official Ubuntu Releases.
2. Flash Ubuntu on USB drive (For this process we recommend using Etcher but any image writing
tool will be good):
Download Etcher and install it.
Plug in USB drive into your computer.
Open Etcher and select from your hard drive .iso file that you downloaded.
Select the USB drive you wish to write your image to.
Review your selections and click 'Flash!' to begin writing data to the USB drive.
3. Plug keyboard and mouse through USB hub to one of the USB-A ports on ROSbot rear panel.
4. Connect monitor to HDMI port on ROSbot rear panel.
5. Plug in USB drive into second USB-A port on ROSbot rear panel.
6. Press "Esc" during booting.
7. You will see blue window with "Enter Password", press "Enter".
Tutorials Manuals Software Downloads Community Log In