+ + + HG Series manual Product Contents + + HG Series HG-2 4PJ12249_V.01.indd 1 Downloaded from www.Manualslib.
Hurom Juicer Manual For Household Use (Warranty Included) 1 Read “Precautions for safe use (Page 4)” carefully and use the appliance properly. 2 Keep the manual within reach anytime and save it for future reference. 3 Check if the voltage indicated on the base of the appliance corresponds to the local voltage before you connect the appliance. 4 Any quality improvements are subject to change without notice.
With Hurom’s own Slow Squeezing Technology and the Juice Cap as an additional mixing function, you can easily make personalized juice in rich tastes and flavors in full preserved valuable nutrients. 1. Much More Nutrients and Taste: Your own personalized juice Various mixed juice Not only enjoying single fruit juice but also adding various ingredients to your taste and health, you can simply make your own HUROM juice.
GENERAL DESCRIPTION AND PARTS NAMES hopper PULP CONTAINER Auger COARSE STRAINER JUICE CONTAINER FINE STRAINER cleaning brush spinning brush small cleaning brush chamber base pusher 02 l HG-2 4PJ12249_V.01.indd 4 Downloaded from www.Manualslib.
SPECIFIC TERMS FOR PARTS 3.Hopper rear arrow 4.Base arrow 5.Chamber arrow 1.Hopper front arrow 6.Operating switch 2.Pulp outlet 7. Juice outlet 8.Juice cap 9.Power cord 10.Grip Strainer * COARSE STRAINER The bigger hole of the strainer produce thicker juice when tender and soft fruits are extracted such as strawberries, kiwis and tomatoes. It is useful to extract more pulpy juice. FINE STRAINER The holes of the strainer are small.
Precautions for safe use All users of this appliance must read and understand this safety precaution before operating. Warning Hazards or unsafe practices which could result in serious personal injury or death. Caution Hazards or unsafe practices which could result in minor personal injury or appliance damage. Sign Examples This sign indicates contents that may cause risk of a fire or an electrical shock. Specific warnings are written in the sign.
warnings and cautions Warning th. ance damage. Hazards or unsafe practices which could result in serious personal injury or death. Do not plug in or unplug with wet hands. It may cause an electric shock or an injury. Do not use other than 230V - 240V AC. It may cause an electric shock, a fire or an abnormal performance. If the voltage is different, it may shorten the life of the motor or cause a failure. Plug the power cord correctly and push it tight in a wall socket.
Warnings and cautions Never disassemble chamber set during operation or insert fingers, foreign objects such as forks, spoons etc. into hopper chute or juice outlet. It may cause an injury, an accident or a failure. THIS APPLIANCE IS NOT INTENDED FOR USE BY PERSONS (INCLUDING CHILDREN) WITH REDUCED PHYSICAL, SENSORY OR MENTAL CAPABILITIES, OR LACK OF EXPERIENCE AND KNOWLEDGE, UNLESS THEY HAVE BEEN GIVEN SUPERVISION OR INSTRUCTION CONCERNING USE OF THE APPLIANCE BY A PERSON RESPONSIBLE FOR THEIR SAFETY.
Warnings and cautions When using the appliance, be careful for a necktie, long necklace, scarf, etc. not to be entangled into hopper chute. It may cause an injury, a failure or a breakage. Place the appliance on a flat and stable surface. It may cause an injury or a failure. 30minute Do not operate the appliance for more than 30 minutes at a time. It may cause a motor failure due to overheating. Cool it down sufficiently about 5 minutes and operate it again.
Slow Juicer assembly STEP 4 Align the chamber arrow [ ] with hopper arrow [ OPEN] and turn the hopper clockwise until it clicks so that the hopper arrow [ CLOSE] aligned with chamber arrow[ ]. OPEN STEP STEP 3 2 Make sure to press the auger down into the strainer in STEP 2. The hopper does not close properly when the auger does not fit in completely. Assemble the parts in the following order: Chamber>Spinning Brush>Strainer. Make sure chamber arrow [ ] aligns with strainer arrow [ ].
Slow Juicer assembly in detail 4 Align the base arrow with the hopper arrow at the rear of the appliance completely. The hopper does not close properly when the parts are not assembled correctly. Hopper rear arrow 2,3 Assemble the parts in the order of chamber> spinning brush> strainer> squeezing auger> hopper (or assemble the spinning brush into the chamber then fit strainer ridge in the chamber inner groove).
How to use the appliance Rear View 2 Wash the fruits and/or vegetables and cut them into pieces that fit into the hopper chute. Place the suitable pieces into hopper chute slowly and press with a pusher. Use fresh fruits and vegetable for juicing as they contain more juice themselves.
Juice cap and extraction seal Juice cap This is the cap of juice outlet in the chamber. Close the juice cap and fill up with juice in the chamber with various ingredients. You can easily make mixed fruit juice or vegetable juice. 1 Juice cap 2 Juice cap 3 Close juice cap and press [ON] button to start. When juice starts filling up the chamber, you can mix banana, nuts, boiled sweet potato, etc. and liquids such as milk, etc. as well as vegetables and fruits like smoothies.
When the auger is stopped during operation (Reverse/Rev button) 1 Click [Reverse/REV] button in operating switches and stop the appliance. Stop 2 Press [Reverse/REV] button in operating switches for 3~5 seconds and release it. Repeat this process 2~3 times. Reverse is the button pushing ingredients upward. Reverse only works while the button is pressed and held. Once release the button, auger rotation stops.
Important safeguards in use ∙ Fruits with pits, hard seeds such as nectarines, peaches, mangos, apricots, plums and cherries must be pitted before juicing. ∙ Cut fibrous ingredients (water parsleys, etc.) in small size like 3~4cm (1.5 inch) and place to the hopper chute. ∙ Drink the fruit juice or green vegetable juice immediately after you have extracted. If it is exposed to air sometime, the juice will lose its taste and natural value.
Disassembly, Cleaning and Care Figure in order 1 3 2 Juice outlet 14 l HG-2 4PJ12249_V.01.indd 16 Downloaded from www.Manualslib.
Disassembly, Cleaning and Care 4 5 1. Ensure the motor stops completely and unplug the power cord. When unplugging the power cord, hold the head part of the power cord and unplug it. Do not touch the power cord with wet hands. 2. Hold the juice outlet and the hopper with both hands and lift them up from the base. 3. Disassemble the parts in reverse as below: 1) Unlock the chamber twisting to counterclockwise. 2) Take the auger out. 3) Remove the strainer.
Chamber disassembly and wash juice cap seal chamber seal 1 Remove Juice Cap seal and chamber seal. Open juice cap first. Hold the chamber and juice cap with one hand and remove juice cap seal with the other hand like taking it off. When removing it, be careful not to drop the juice cap and chamber. It may cause damage to the juice cap. Remove the chamber seal like pinching and twisting it with two fingers. Extraction Seal the extraction seal at the bottom 2 Open of the chamber.
Sterilization and Easy Cleaning System Sterilization For sterilization, use baking soda or natural wash-up liquids only. You can thoroughly wash them immersing in the water diluted with one or two drops of baking soda or natural wash-up liquids for about 30 minutes. Easy Cleaning System closing the juice cap, pour the water a while, open the juice cap and 1 After 2 After into hopper chute and operate the appliance. discharge the water.
Spinning brush disassembly and wash 1 spinning brush silicone brush 2 3 Remove the spinning brush from strainer. Detach the silicone brush from spinning brush. As shown to the left, hold the outer part of silicone brush with your fingers and pull it out to the arrow direction. It is recommendable to remove it according to the above method. If pulling it by force, silicone brush may be torn or spinning brush may be damaged.
Spinning brush assembly Spinning brush Silicone brush 1 Inner wing 1 Up (longer part) 2 Outer wing Brush groove Check the groove of the spinning brush and the direction of silicone brush. There are grooves to insert silicone brush in the spinning brush. Silicone brush has inner wing ❶1 and outer wing ❷2 . As shown to the left, let ‘inner wing’ face the spinning brush. Down (shorter part) 1 2 Insert the silicone brush into the spinning brush. According to the No.
Chamber seal assembly 1 Hold the chamber seal like pinching. 2 Insert the chamber seal into the chamber hole. As shown to the left in a dotted circle, let the protrusion part on the chamber seal face upward and hold it like pinching with your thumb and index finger. Chamber seal 3 Insert the bottom of the chamber seal into the chamber hole and fully press it down. Do not insert whole part of chamber seal. The upper part of the chamber seal must be shown.
Juice cap seal assembly 1 Hold juice cap seal as shown to the left. 2 Open the juice cap and insert the juice cap seal in. 3 Organize the seal to seal off completely. As shown to the left in a dotted circle, the hole must be visible when you hold. Juice cap seal Insert it in from the top to the juice cap. Be careful not to drop the chamber. If the seal is not completely sealed, it may cause juice leaking. www.hurom.com l 21 HG-2 4PJ12249_V.01.indd 23 Downloaded from www.Manualslib.
Troubleshooting Check the details below before contacting Technical Support for repair or service. If you need information or if you have a problem, please contact the local Customer Care Center or visit www.hurom.com. When applying for after sales service, check the manufacturer’s serial number or bar code. The appliance does not work. Make sure the power cord is properly plugged in. Check the hopper is assembled properly.
Appliance Specifications Appliance Standards Product name Hurom Slow Juicer Model name HG Series Rated voltage 230-240 V Rated frequency 50 Hz Rated Power Consumption 150 W RPM (revolutions per minute) 42 rpm Cord length 1.4 m이상 Motor Single-phase induction motor Fuse 250 V 5 A Weight 5.4 kg (11.9 lb) Outward Dimensions Width 160 mm Length 224 mm Height 418 mm Rated operating hour less than 30 minutes www.hurom.com l 23 HG-2 4PJ12249_V.01.indd 25 Downloaded from www.Manualslib.
Warranty Product name Model name Manufacture’s serial number Date of purchase Supplier Customer name Address Important: To better protect your purchase, fill out and mail this form to a local distributor where you have purchased, and keep the original receipt. This certifies that the Hurom Slow Juicer is warranted by and workmanship.
MEMO www.hurom.com l 25 HG-2 4PJ12249_V.01.indd 27 Downloaded from www.Manualslib.
2 4PJ12249_V.01 www.hurom.com HG-2 4PJ12249_V.01.indd 28 Downloaded from www.Manualslib.
