Programming Instructions Manual
Table Of Contents
- Table of Contents
- INSTALLATION
- CONTROLLER PROGRAMMING AND OPERATION
- Watering Schedule
- Programming the Controller
- Setting the Date and Time
- Setting the Program Start Time(s)
- Eliminating a Program Start Time
- Setting Station Run Times
- Setting Days To Water
- Selecting Specific Days of the Week to Water
- Selecting Odd or Even Days to Water
- Selecting Interval Watering
- Setting Event Day(s) Off
- Automatic Watering
- System Off
- Programmable Rain Off
- Seasonal Adjustment
- Manually Run a Single Station
- Manually Run All Stations
- One Touch Manual Start and Advance
- Advanced Features
- TROUBLESHOOTING AND SPECIFICATIONS
ENG
14
TROUBLESHOOTING GUIDE (cont.)
SPECIFICATIONS
Operating Specifications
• Station Run Times: 0 to 4 hours in 1-minute
increments.
• 3 Independent Watering Programs.
• Start Times: 4 per day per program for
up to 12 daily starts.
• Watering Schedule: 365-day calendar,
interval watering, odd/even watering.
• AM/PM, 24-hour clock.
• Simple manual operation.
• Sensor override by station.
• Programmable rain delay (1 to 7 days).
• Seasonal adjustment (10% to 150%).
• Sensor bypass switch.
• XC-x00i for indoor use. XC-x00 for
outdoor use.
• Sea level to 2000m at 0-50°C.
Electrical Specifications
• Transformer input 120VAC ±10% 60 Hz
(230VAC ±10% 50/60 Hz International
Models).
• Transformer Output: 24VAC 1.0 amp.
• Station Output: .56 amps per station.
• Maximum Output: .90 amps
(includes master valve).
• Battery: 3V Lithium (included) used for re
-
mote programming and backup timekeep-
ing. Use CR2032 3-volt.
• Electronic short circuit protection.
• Non-volatile memory for program data.
• UL Listed.
• Model XC-x00 has an IP24 Rating for
Pollution Degree 4.
• Clean only with a cloth dampened with
mild soap and water.
PROBLEM CAUSES SOLUTIONS
Display shows a station is running but the
and icons are flashing.
The sensor is interrupting irrigation, however
the station has been programmed to
override the sensor.
Check the sensor override status (see page 10).
Automatic irrigation does not start at the
start time and controller is not in the
System Off mode.
AM/PM of time of day not set correctly.
AM/PM of start time not set correctly.
Start Time is disabled (set for Off).
Controller is not receiving AC power.
Correct AM/PM of time of day.
Correct AM/PM of start time.
See Setting Start Times (pg 7).
Check AC power connections.
Explanation of Symbols
= AC
= Consult Documentation
= Hazardous Voltages Present
= Ground